Cayin CDT-17A

jessie52
jessie52 Posts: 34
edited September 2011 in DIY, Mods & Tweaks
What capacitors would do well with the Cayin CDT-17A. Four caps are critical for upgrades: two 2.2uf and two .22uf.
Post edited by jessie52 on
· Share on FacebookShare on Twitter

Comments

  • inspiredsports
    inspiredsports Posts: 5,501
    edited September 2011
    I've had good luck with Audience Auricaps in the signal paths of my recapped/rebuilt amp and preamp
    VTL ST50 w/mods / RCA6L6GC / TlfnknECC801S
    Conrad Johnson PV-5 w/mods
    TT Conrad Johnson Sonographe SG3 Oak / Sumiko LMT / Grado Woodbody Platinum / Sumiko PIB2 / The Clamp
    Musical Fidelity A1 CDPro/ Bada DD-22 Tube CDP / Conrad Johnson SD-22 CDP
    Tuners w/mods Kenwood KT5020 / Fisher KM60
    MF x-DAC V8, HAInfo NG27
    Herbies Ti-9 / Vibrapods / MIT Shotgun AC1 IEC's / MIT Shotgun 2 IC's / MIT Shotgun 2 Speaker Cables
    PS Audio Cryo / PowerPort Premium Outlets / Exact Power EP15A Conditioner
    Walnut SDA 2B TL /Oak SDA SRS II TL (Sonicaps/Mills/Cardas/Custom SDA ICs / Dynamat Extreme / Larry's Rings/ FSB-2 Spikes
    NAD SS rigs w/mods
    GIK panels
    · Share on FacebookShare on Twitter
  • chargerman426
    chargerman426 Posts: 419
    edited September 2011
    I upgraded the output caps in my Cj pre to Mulindorf suprems, sound great and aren't going to brake the bank compared to some of the other "high-end" caps out there.
    If life had more tubes it would be a lot smoother.
    · Share on FacebookShare on Twitter