Tsi400 vs TRi A7
tiberius1023
Posts: 9
I'm having trouble deciding between the Tsi400s and the TRi A7s. I've heard the 400s in person so I know what they sound like. There's a pretty big price difference between the 2. Are the A7's worth the additional cost?
Post edited by tiberius1023 on
Comments
-
In short....yes. The A7's will require alittle more juice to sound their best than the 400's though so take that into consideration.HT SYSTEM-
Sony 850c 4k
Pioneer elite vhx 21
Sony 4k BRP
SVS SB-2000
Polk Sig. 20's
Polk FX500 surrounds
Cables-
Acoustic zen Satori speaker cables
Acoustic zen Matrix 2 IC's
Wireworld eclipse 7 ic's
Audio metallurgy ga-o digital cable
Kitchen
Sonos zp90
Grant Fidelity tube dac
B&k 1420
lsi 9's -
What receiver would you recommend? Right now I have an onkyo 606....runs really hot...wouldn't mind replacing it.
-
I don't see pre-outs for the mains on the Onk, otherwise I would suggest just getting an external amp for them. I would look for a reciever with pre-outs for all channels if possible, and one that had all the features you want for your setup. Pioneer makes some nice stuff, as does Denon, Onkyo and the higher end Yamahas. I have no experience with the RTi's but I can say my mid-level Yami and the Moniotor 50's I had were very bright sounding. RTi's are a bit better in that regards but others still say the pairing with Yamha can be a tad on the bright side.The Gear... Carver "Statement" Mono-blocks, Mcintosh C2300 Arcam AVR20, Oppo UDP-203 4K Blu-ray player, Sony XBR70x850B 4k, Polk Audio Legend L800 with height modules, L400 Center Channel Polk audio AB800 "in-wall" surrounds. Marantz MM7025 stereo amp. Simaudio Moon 680d DSD
“When once a Republic is corrupted, there is no possibility of remedying any of the growing evils but by removing the corruption and restoring its lost principles; every other correction is either useless or a new evil.”— Thomas Jefferson -
On the Yamaha front, I think someone mentioned recently that the new RX-A series AVRs were not as bright as the RX-V series. Op may want to google a bit on that to verify - otherwise, the new Yamahas look pretty attractive as well. And they tend to include pre-outs at a lower price point.
I love my Denon, but pre-outs are only included in the 331x models and higher, which start at over $1k. Onkyo and Pioneer tend to include pre-outs at a lower price point as well.ALL BOXED UP for a while until I save up for a new place
Home Theater:
KEF Q900s / MIT Shotgun S3 / MIT CVT2 ICs | KEF Q600C | Polk FXi5 | BJC Wire | Signal / AQ ICs | Shunyata / Pangea PCs | Pioneer Elite SC 57 | Parasound NC2100 Pre | NAD M25 | Marantz SA8001 | Schiit Gungnir DAC | SB Touch
2 Channel:
Polk LSi9 (xo mods), Polk DSW MicroPro 2000 sub | NAD c375BEE | W4S DAC1 | SB Touch | Marantz SA-8001 | MIT AVt 2 | Kimber Hero / AQ / Signal ICs | Shunyata / Signal PCs