can you tell me if a jumper is needed

leftwinger57
leftwinger57 Posts: 2,917
edited July 2011 in Speakers
Hello, I have heard so much of these SRS-SDS speakers and how good they really are. The concern I have is that I keep hearing that you need a jumper between both speakers and in a house like mine that would be physically impossible unless yuo know how to either pull carpet or pull mouldings which as a former alarm installer I know how to do. So can someone please answer this question of a bonding wire between the two speakers. This is a curiosity that is bugging me.....lw
2chl- Adcom GFA- 555-Onkyo P-3150v pre/amp- JVC-QL-A200 tt- Denon 1940 ci cdp- Adcom GFS-6 -Modded '87 SDA 2Bs - Dynamat Ext.- BH-5- X-Overs VR-3, RDO-194 tweeters, Larry's Rings, Speakon/Neutrik I/C- Cherry stain tops Advent Maestros,Ohm model E

H/T- Toshiba au40" flat- Yamaha RX- V665 avr- YSD-11 Dock- I-Pod- Klipsch #400HD Speaker set-

Bdrm- Nikko 6065 receiver- JBL -G-200s--Pioneer 305 headphones--Sony CE375-5 disc
· Share on FacebookShare on Twitter

Comments

  • dorokusai
    dorokusai Posts: 25,577
    edited July 2011
    You need a cable to connect both loudspeakers. It's called an SDA cable and it comes in a couple forms depending on the speaker. It's not just a jumper as it is essential to the speaker working as intended and correctly.
    CTC BBQ Amplifier, Sonic Frontiers Line3 Pre-Amplifier and Wadia 581 SACD player. Speakers? Always changing but for now, Mission Argonauts I picked up for $50 bucks, mint.
    · Share on FacebookShare on Twitter