CRS+ parts needed - x-over and PR
DollarDave
Posts: 2,575
I need 1 PR and 1 x-over to restore a pair of CRS+'s.
I need to add that it is for the right speaker (if that matters) and it is pin-blade style.
I will verify, but I think the PR is a 102.
Right now, I think that is all I will need. I'm anxious to get a pair up and going again.
I need to add that it is for the right speaker (if that matters) and it is pin-blade style.
I will verify, but I think the PR is a 102.
Right now, I think that is all I will need. I'm anxious to get a pair up and going again.
Post edited by DollarDave on
Comments
-
There is a pair of CRS PRs on ebay right now. I thought that the passive was the same in the CRS and CRS+, but I could not find the driver list.
http://cgi.ebay.com/Polk-audio-10-passive-radiator-grill-SDA-COMPACT-/250838091817?pt=Vintage_Electronics_R2&hash=item3a671d8829#ht_500wt_1142 -
Thanks, I sent the seller a message to verify the part number and to see if the auction is for one or two.
-
I forgot to mention that the CRS+ and the SDA 2B share the same x-over. So, either one works, and there isn't a left and a right.
I checked and the PR is an SW100, not a 102 as I expected based on the pin/blade version of the CRS+'s. -
I've procured a set of passives from the auction site.
now, I only need one x-over (or a pair of) for either an SDA 2b, or an SDA CRS+.
