PSW505 packaging

vez
vez Posts: 2
edited March 2011 in Speakers
Hi,

I just bought a new PSW505 sub. There is packaging material (thin styrofoam kind) between the front grill and body of the speaker. Is this normal? How do I remove it safely? I am wondering if pulling out the grill to remove packaging will result in losing the snug fit of grill?

Any suggestions are appreciated.

Thanks,
Vez

PS: Excuse me for posting in the advanced section. I should have posted in basics-how to. Not sure how to delete this post and post again.
Post edited by vez on
· Share on FacebookShare on Twitter

Comments

  • PrazVT
    PrazVT Posts: 1,606
    edited March 2011
    The front grill comes off :)
    ALL BOXED UP for a while until I save up for a new place :(

    Home Theater:
    KEF Q900s / MIT Shotgun S3 / MIT CVT2 ICs | KEF Q600C | Polk FXi5 | BJC Wire | Signal / AQ ICs | Shunyata / Pangea PCs | Pioneer Elite SC 57 | Parasound NC2100 Pre | NAD M25 | Marantz SA8001 | Schiit Gungnir DAC | SB Touch

    2 Channel:
    Polk LSi9 (xo mods), Polk DSW MicroPro 2000 sub | NAD c375BEE | W4S DAC1 | SB Touch | Marantz SA-8001 | MIT AVt 2 | Kimber Hero / AQ / Signal ICs | Shunyata / Signal PCs
    · Share on FacebookShare on Twitter