How to mount TSi200 to a speaker stand

FriscoJoe
FriscoJoe Posts: 1
edited February 2011 in Speakers
I will be purchasing the TSi200 bookshelf speakers and want to put them on stands. It is not obvious to me how these actually mount to the stand.

Considering these stands:
http://www.parts-express.com/pe/showdetl.cfm?Partnumber=240-802

How do I know if the mounting studs are compatible? Sorry if this is a newb question..but I'm a newb :wink:
Post edited by FriscoJoe on
· Share on FacebookShare on Twitter

Comments

  • dwd999
    dwd999 Posts: 8
    edited February 2011
    normally you would just put the neoprene cushions on the top of the stand and set the speakers on top without actually bolting them on. unless you anticipate people knocking them off the stands in which case you could get some wood screws and screw the stands onto the speaker cabinets.
    · Share on FacebookShare on Twitter
  • jbooker82
    jbooker82 Posts: 1,627
    edited February 2011
    Ethire that or get some industrial strenght velcro. You might get a slight vibration / resonance by not using a ruber isolator between the stand and speaker though.
    AVR: Onkyo Tx-NR808
    Amplifier: Carver A-753x 250 watts x 3
    Fronts: Polk RTI A7 (modded by Trey VR3)
    Center: CSI A4 (modded by Trey VR3)
    Rear: FXI A4
    Sub: Polk DSW Pro 660wi
    TV: LG Infinia 50PX950 3D
    Speaker Cable: AudioQuest Type 8
    IC: AudioQuest Black Mamba II
    · Share on FacebookShare on Twitter