I c wires
leftwinger57
Posts: 2,917
HELLO, again and I've come across this thread that most of this forum take uber seriously. Now I need to make shure were talking about the same wire and what it does. Are they the interconnectors fom a power amp to a pre-amp. Now if so I have seen on Audioagon wires like these in the houndreds if not thousand for a meter or 2 . Is this true, can this wire from any top maker be such a difference. Again not to start the Rodger Russel wire troll thread on speaker wire, are thes I-CS that important. I must say I did a minor experiment
and changed out my heavy duty RCAs w/ solo Phillips and then seperated all power wires,routeing them away from any other wires and I think there is some clarity here. But those prices, come in their own satchells it unerves me somewhat,but I might be the one to be converted if you could chime in.
and changed out my heavy duty RCAs w/ solo Phillips and then seperated all power wires,routeing them away from any other wires and I think there is some clarity here. But those prices, come in their own satchells it unerves me somewhat,but I might be the one to be converted if you could chime in.
2chl- Adcom GFA- 555-Onkyo P-3150v pre/amp- JVC-QL-A200 tt- Denon 1940 ci cdp- Adcom GFS-6 -Modded '87 SDA 2Bs - Dynamat Ext.- BH-5- X-Overs VR-3, RDO-194 tweeters, Larry's Rings, Speakon/Neutrik I/C- Cherry stain tops Advent Maestros,Ohm model E
H/T- Toshiba au40" flat- Yamaha RX- V665 avr- YSD-11 Dock- I-Pod- Klipsch #400HD Speaker set-
Bdrm- Nikko 6065 receiver- JBL -G-200s--Pioneer 305 headphones--Sony CE375-5 disc
H/T- Toshiba au40" flat- Yamaha RX- V665 avr- YSD-11 Dock- I-Pod- Klipsch #400HD Speaker set-
Bdrm- Nikko 6065 receiver- JBL -G-200s--Pioneer 305 headphones--Sony CE375-5 disc
Post edited by leftwinger57 on
Comments
-
YEs you are correct pe-amp to amp apparently these do make a difference your decision so reasearch and get a good one for your equipment.
