speakers and wiring for mmats d200hc amp?

Systems
Systems Posts: 14,873
edited August 2003 in Car Subwoofer Talk
I have a MMats class D amp model number= d200hc. It is 1ohm stable with two channels. I recentely had 4 polk dx 10" speakers running off of it. two speakers were run in parallel off of one channel. To cut the story short a couple of my speakers are blown and I want to get new speakers. I really want to get the most bass I can from this amplifier. What kind of speakers would be good for this amp? I was thinking about two bad **** 12's or 10's. Any advice would be greatly appreciated.
Testing
Testing
Testing
Post edited by Unknown User on
· Share on FacebookShare on Twitter

Comments

  • PoweredByDodge
    PoweredByDodge Posts: 4,185
    edited August 2003
    well how much power does the amp do???

    assuming it did enough for 4 dx 12's then i dont see why you cant run 4 momo 10's or maybe 4 momo 12's.
    The Artist formerly known as PoweredByDodge
    · Share on FacebookShare on Twitter
  • Systems
    Systems Posts: 14,873
    edited August 2003
    The amp is rated at 1200 watts at 1 ohm. But I am sure it is underrated as it blew some of my 10's. I would really like to get two speakers instead of four because I have limited trunk space. Do you know of any speakers that would wire up to 1 ohm and take the power of this amp so I would only have two speakers in my trunk instead of four?
    Testing
    Testing
    Testing
    · Share on FacebookShare on Twitter
  • PoweredByDodge
    PoweredByDodge Posts: 4,185
    edited August 2003
    two subs at 1 ohm and 600+ rms each...

    - alpine type R 12" swr-1241D
    - alpine type R 15" swr-1541D

    - image dynamics idq 15" v2 d4

    - phoenix gold titanium 10" dual 4 ohm coil
    - phoenix gold titanium 15" dual 4 ohm coil

    - rf punch hx2 12" dual 4 ohm coil
    - rf punch hx2 15" dual 4 ohm coil

    - xtant x 12" dual 4 ohm coil
    The Artist formerly known as PoweredByDodge
    · Share on FacebookShare on Twitter