PSW 505 - Setup Question
chaka1234
Posts: 3
Good Day,
Just picked up a Polk Monitor PSW 505 Sub to go with my new Monitor 70's and CS2 II, rears will be Monitor 30's when Newegg has them on sale again.
I am running it from an older NAD AV-716 for now, it has a Subwoofer Out which based on the manual states that it provides a "unfitered" output.
Do I connect the output into the LFE (unfitered) or Line In (filtered), the Polk manual is not clear.
I did do a search but could not find any information on this type of setup.
Also I have set the Low Pass to 120Hz, but I have read to set it to 80Hz. Sub volume is at 12:00pm, but I have read to set it to about 10am on the dial.
Thanks.
Just picked up a Polk Monitor PSW 505 Sub to go with my new Monitor 70's and CS2 II, rears will be Monitor 30's when Newegg has them on sale again.
I am running it from an older NAD AV-716 for now, it has a Subwoofer Out which based on the manual states that it provides a "unfitered" output.
Do I connect the output into the LFE (unfitered) or Line In (filtered), the Polk manual is not clear.
I did do a search but could not find any information on this type of setup.
Also I have set the Low Pass to 120Hz, but I have read to set it to 80Hz. Sub volume is at 12:00pm, but I have read to set it to about 10am on the dial.
Thanks.
Post edited by chaka1234 on
Comments
-
Use the filtered input. The LFE input on the sub bypasses the internal high pass relying on the filter in the receiver. HTH.
![[Deleted User]](https://w2.vanillicon.com/2f1750dcdda3cf49f1655cb299e53ec8_100.png)