Nice SDA 1Cs with walnut ends

geppy1
geppy1 Posts: 3,076
edited October 2010 in For Sale (FS) Classifieds
I am selling my Polk SDA 1Cs with walnut ends. These have had the drivers Mortited. These are from Sept of 87 and where blade on blade but now have the later nice 1 piece crossover boards in them. The IC cable is a homemade with 2 12GA monster cables connected to a bannana plug on each end. The blade blade spot has been plugged and a bannana jack is installed on back above the speaker terminals. Sounds way better then the original IC All drivers work and are in great shape. The cabinets are in great shape as are the grills. There is a waterstain on top of one cap. See the picture. Not bad at all. Asking $450. Check my feedback. Thanks,keith
004.jpg 522.7K
005.jpg 496.5K
006.jpg 520.1K
Post edited by geppy1 on
· Share on FacebookShare on Twitter

Comments

  • dcmartinpc
    dcmartinpc Posts: 844
    edited October 2010
    Interested. Where are you located?

    Thanks!

    Don
    Living Room: Adcom GFP-750 (Upgraded), Squeezebox Touch, Oppo BDP-83, Pioneer DV-79AVi, Parasound HCA-3500 (Upgraded), SDA SRS 2 P/B (Gimpod, Sonicaps, & Mills)

    Theater: Denon 4311ci, Oppo BDP-93, Parasound HCA-2205+HCA-2200II, Polk LSi9, LSiC, LSiFX, LSi7, Custom 18" TC Sounds sub with 2 18" PR, Sharp XV-Z12000, Pioneer Kuro KRP-500M (isf Enabled)

    Bedroom: HK AVR354, Pioneer DV-47a, Parasound HCA-1500a, Polk LSi9
    · Share on FacebookShare on Twitter
  • geppy1
    geppy1 Posts: 3,076
    edited October 2010
    MN Minneapolis StPaul
    · Share on FacebookShare on Twitter
  • Toolfan66
    Toolfan66 Posts: 18,183
    edited October 2010
    Geppy,

    Sometimes I think you have your own polk audio / audio store..;)
    · Share on FacebookShare on Twitter