Do i have to bridge my amp?

JL Audio
JL Audio Posts: 5
edited October 2010 in Car Audio & Electronics
i have a 2 channel amp that is 2 ohms: 250 watts x 2 chan. and a sub that is RMS Power Range : 75-300 Watts. Do i have to bridge it or do i just hook up the one sub to one channel on the amp, will this work?
Post edited by JL Audio on
· Share on FacebookShare on Twitter

Comments

  • JL Audio
    JL Audio Posts: 5
    edited October 2010
    sorry for the newbie post but i am new to this audio thing
    · Share on FacebookShare on Twitter
  • Vital
    Vital Posts: 747
    edited October 2010
    post exact model of your amp and sub
    2008 Nissan Altima
    Kenwood DNX 5140
    Arc Audio IDX and XEQ
    Polk Audio SR6500 active and SR124-dvc sealed
    Polk Audio PA500.4 and PA1200.1
    · Share on FacebookShare on Twitter
  • JL Audio
    JL Audio Posts: 5
    edited October 2010
    I have a JL 12 inch W3 2ohm and a Kenwood KAC-7205 2 channel amplifier 1000 watt
    · Share on FacebookShare on Twitter
  • Vital
    Vital Posts: 747
    edited October 2010
    JL 12 inch W3 2ohm isn't a model number.
    when i type that in google it gives me JL Audio 12W3v3-2 which is 500W RMS, not 75-300 like u stated in your first post.

    what's exact model of your sub?? It is stated on box/manual and in most cases on the back of the sub.
    2008 Nissan Altima
    Kenwood DNX 5140
    Arc Audio IDX and XEQ
    Polk Audio SR6500 active and SR124-dvc sealed
    Polk Audio PA500.4 and PA1200.1
    · Share on FacebookShare on Twitter