ring install not going too smooth
sda2mike
Posts: 3,131
ok..i'm no bob villa:p..i'm only posting about lefty so far...on my outside mw, the center brace is a smidge too close, so the ring doesn't fit..:mad: also, the ring for the pr doesn't go in the hole, duh...should i get a hacksaw and cut it in half..same w the mw? just cut a little off the edge? criminy! it was going smoothly!
Post edited by sda2mike on
Comments
-
If you look at the PR ring, you will see two small cuts on opposite sides. You gently bend the PR ring at those two points until it slips inside the hole. You then bent it back flat before inserting the threaded pins into the 9/32" holes you drilled with the template.
As for the MW ring, you'll have to either trim the brace or the ring, your choice.Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
If you look at the PR ring, you will see two small cuts on opposite sides. You gently bend the PR ring at those two points until it slips inside the hole. You then bent it back flat before inserting the threaded pins into the 9/32" holes you drilled with the template.
As for the MW ring, you'll have to either trim the brace or the ring, your choice.
very cool...thank you -
Mike I had one side that both the MWs rings had to be trimmed. The brace was actually past the hole about 1/16. No biggie though.Speakers: SDA-1C (most all the goodies)
Preamp: Joule Electra LA-150 MKII SE
Amp: Wright WPA 50-50 EAT KT88s
Analog: Marantz TT-15S1 MBS Glider SL| Wright WPP100C Amperex BB 6er5 and 7316 & WPM-100 SUT
Digital: Mac mini 2.3GHz dual-core i5 8g RAM 1.5 TB HDD Music Server Amarra (memory play) - USB - W4S DAC 2
Cables: Mits S3 IC and Spk cables| PS Audio PCs
