Lsi25 setup
Frank
Posts: 2
With the following Polk Audio speakers 5.1 setup:
Main: Lsi25
Center: LsiC
Surrond: Lsi f/x
Sub: PSW505
preamp: Outlaw 950
amp: Outlaw 770 7 channnel
1. Is there any benefit to bi wiring all my speakers (except sub) if I set up my Lsi25's by running a rca cable (split) from the l/r preout (preamp) to l/r input (amp) and to the Lsi25 sub in. Then sub out (preamp) to LFE in (subwoofer). Set sub to yes and all others to large. Uncertain of the freq for each speaker.
Any advise is welcomed. This is a great forum to ask
thx's
guys
Main: Lsi25
Center: LsiC
Surrond: Lsi f/x
Sub: PSW505
preamp: Outlaw 950
amp: Outlaw 770 7 channnel
1. Is there any benefit to bi wiring all my speakers (except sub) if I set up my Lsi25's by running a rca cable (split) from the l/r preout (preamp) to l/r input (amp) and to the Lsi25 sub in. Then sub out (preamp) to LFE in (subwoofer). Set sub to yes and all others to large. Uncertain of the freq for each speaker.
Any advise is welcomed. This is a great forum to ask
thx's
guys
Post edited by Frank on
Comments
-
LSiC: bi-wire
LSi f/x: bi-wire
LSi25: bi-wire top half with binding straps removed
Left LSi25 sub: line level Left pre-out to subwoofer in
Right LSi25 sub: line level Right pre-out to subwoofer in
PSW505: line level sub pre-out out to LFE (unfiltered) jack
Bass management settings:
Mains = Large
Sub = Yes
Center = Small
Surrounds = Small
Doc"What we do in life echoes in eternity"
Ed Mullen (emullen@svsound.com)
Director - Technology and Customer Service
SVS
