Front High Speakers and Binding Posts
rbullis
Posts: 2
Hello,
I am new to Club Polk. I just purchased a set of RTi A9's, A7's and A5's. A CSi A6 and a set of FXi A6's for my HT setup.
RTi A9: Front mains
RTi A7: Front Wide left and right
RTi A5: Surround left and right
CSi A6: Center
FXi A6: Rear surround left and right
I am thinking of a set of the LC65fx or LC80f/x for the Front High speakers since they can be mounted into the wall flush. Have not decided what to do for these speakers..OPEN FOR SUGGESTIONS.
Also I have a question on the binding posts, I am not Bi-Amping the speakers. I have attached a picture of the binding post for convenience, please see attachment. These questions may be dumb ones, but here they are.
1. Do you connect the speaker wire to the Bottom set or top set of Binding Posts?
2. Has anyone noticed a differance in sound quality from using the top or bottom Binding Posts?
Please excuse the questions if they are lame to you. I am just trying to clear up a massive amount of conflicting advice on these binding posts...any constuctive advice is welcome.
And Thank you in advance:)
I am new to Club Polk. I just purchased a set of RTi A9's, A7's and A5's. A CSi A6 and a set of FXi A6's for my HT setup.
RTi A9: Front mains
RTi A7: Front Wide left and right
RTi A5: Surround left and right
CSi A6: Center
FXi A6: Rear surround left and right
I am thinking of a set of the LC65fx or LC80f/x for the Front High speakers since they can be mounted into the wall flush. Have not decided what to do for these speakers..OPEN FOR SUGGESTIONS.
Also I have a question on the binding posts, I am not Bi-Amping the speakers. I have attached a picture of the binding post for convenience, please see attachment. These questions may be dumb ones, but here they are.
1. Do you connect the speaker wire to the Bottom set or top set of Binding Posts?
2. Has anyone noticed a differance in sound quality from using the top or bottom Binding Posts?
Please excuse the questions if they are lame to you. I am just trying to clear up a massive amount of conflicting advice on these binding posts...any constuctive advice is welcome.
And Thank you in advance:)
Post edited by rbullis on
Comments
-
Doesn't matter which set, as long as you don't ever cross wires/etc. you'll be fine.
Since you just got your speakers, give them plenty of time to burn in before passing any judgement, trust me they'll just sound better and better as they break in.
And welcome to CP!Truck setup
Alpine 9856
Phoenix Gold RSD65CS
For Sale
Polk SR6500
Polk SR5250
Polk SR104Any clue how to use the internet? Found it in about 10 sec. -
What will you be using to drive all of these speakers ?HT SYSTEM-
Sony 850c 4k
Pioneer elite vhx 21
Sony 4k BRP
SVS SB-2000
Polk Sig. 20's
Polk FX500 surrounds
Cables-
Acoustic zen Satori speaker cables
Acoustic zen Matrix 2 IC's
Wireworld eclipse 7 ic's
Audio metallurgy ga-o digital cable
Kitchen
Sonos zp90
Grant Fidelity tube dac
B&k 1420
lsi 9's -
Integra Preamp DHC-80.1
Integra Amplifier DTA 70.1
