Early 1cs with blade blade
geppy1
Posts: 3,075
On very early 1cs with blade and blade which blade carries the signal??? keith
Post edited by geppy1 on
Comments
-
both
pin - blade only has the one carrying the signal - the pin. -
Hummm I don't think so...
I am sure the upper blade only carries the signal. ( the small blade)Polk Audio SDA 2.3tl Fully Hot Rodded. 😎
SVS SB16 X2
Cary SLP-05/Ultimate Upgrade.
Cary SA-500.1 ES Amps
Cary DMS 800PV Network
OPPO UDP 205/ModWright Modification
VPI Scout TT / Dynavector 20x2
Jolida JD9 Fully Modified
VPI MW-1 Cyclone RCM
MIT Shotgun 3 cables throughout / Except TT, and PC’s -
I think on the 1C it is only one blade Just which one??
-
I have a pair of the b/b 1C's. it's the upper blade although I believe there is continuity between the lower blades on the SDA cable. Nothing coming from the crossover to the lower blade.
-
Correct!!!
The small blade should be sending the signal... If you pull the passive there should be a blue wire to the top blade. that is the blade sending the SDA signal...Polk Audio SDA 2.3tl Fully Hot Rodded. 😎
SVS SB16 X2
Cary SLP-05/Ultimate Upgrade.
Cary SA-500.1 ES Amps
Cary DMS 800PV Network
OPPO UDP 205/ModWright Modification
VPI Scout TT / Dynavector 20x2
Jolida JD9 Fully Modified
VPI MW-1 Cyclone RCM
MIT Shotgun 3 cables throughout / Except TT, and PC’s -
This references pin blade, but the wiring setup "might" be helpful.
http://www.polkaudio.com/forums/attachment.php?attachmentid=31012&d=1201824729 -
Point being if I am making a new larger cable i only need one blade on each end as i believe the lower blade is for centering or stability. I know that is true on the pin blade ones. Keith
