westmassguy

  • Re: SRS 1.2 no bass

    westmassguywestmassguy
    Any problem with the large spool inductor would only affect the one speaker it was located in. The crossovers may have been mucked up by someone previously. With the interconnect in place, and if tho…
    ·

  • Re: SRS 1.2 no bass

    westmassguywestmassguy
    Push in and hold the PR. All the woofers should extend fully, and begin to retract after 3-5 seconds. I would also check and make sure the sub-bass drive inductors are connected. The large spool indu…
    ·

  • Re: monitor 12 crossover

    westmassguywestmassguy
    No! Do not remove the Polyswitches on those. They're revised. Note how it's shunting the small cap. See Schematic_M12_REV
    ·

  • Re: Looking for advice on RTA11T's

    westmassguywestmassguy
    The RTA-11s have quite a bit of internal bracing. If the cabinets are that beat up, and vibrating, it's possible some of the bracing has broken loose. As for budget constraints, don't skimp…
    ·

  • Re: Off the Floor

    westmassguywestmassguy
    The Monitor 10s were designed to be used on Polk's stands, which raise them about 5-6" off the floor, with a 6 degree rake for time alignment.
    ·
Avatar