Blowing Fuses! Help!

SystemsSystems Posts: 14,998
edited November 2001 in Car Audio & Electronics
Hello, I have 2 12" Polk/MOMOs running off of an Autotek-MX1300 at 2 ohm. It is pushing about 600x2. The problem is recently I just changed it from 4 ohm to 2 ohm and when i changed it to 2 ohm I blew a 40a, 60a, and 80a fuse in my 4awg power wire. Everything was running perfect when I was running at 4 ohm but when it came down to 2 ohm..this fuse popping problem arose. I didnt change any other connections other than running parrallel from series. The 80a fuse took about 2 minutes to melt and the 40a and 60a took about 30 seconds.
What should/can I do to stop popping fuses left and right?
Testing
Testing
Testing
Post edited by Unknown User on

Comments

  • polkaudiosupra101polkaudiosupra101 Posts: 48
    edited November 2001
    this has happened to me too. i think its because your ohms are too low. the fuse burnin out is the amp protecting itself from overloading or you need smaller gauge wire. if i were you id run them parallel or something but i dont know what your power peaks are, so hopefully that will solve your problem.
Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!