2 subs

Options
gracenrich
gracenrich Posts: 3
edited February 2003 in Subwoofer Hookup & Bass Management
Hi All
I have 2 subs a Polk 350 connected
and a larger M&K not connected.
They are approx 8 ft.apart.
What would be the best way to connect them?
I am now using the Polk way.
Would it be beneficial to connect them?
Thank You:rolleyes:
R.Gordon
Post edited by gracenrich on
· Share on FacebookShare on Twitter

Comments

  • goingganzo
    goingganzo Posts: 2,793
    edited February 2003
    Options
    i allways use lfe always
    dasy chane the 350
    · Share on FacebookShare on Twitter
  • gracenrich
    gracenrich Posts: 3
    edited February 2003
    Options
    Thank You but how do I daisy chain the subs?
    R.Gordon
    · Share on FacebookShare on Twitter
  • Dr. Spec
    Dr. Spec Posts: 3,780
    edited February 2003
    Options
    Buy a Y splitter and run it off the LFE and connect a sub cable to each sub.
    "What we do in life echoes in eternity"

    Ed Mullen (emullen@svsound.com)
    Director - Technology and Customer Service
    SVS
    · Share on FacebookShare on Twitter
  • wlrandall
    wlrandall Posts: 440
    edited February 2003
    Options
    That's not daisy chained, that's parallel. Daisy chained is series (out to in, same device out to the next in, etc...).

    I think Doc will back me on this one, but you should have them all driving from a single point. Stack those babies and find what you've been missing!

    Wally
    · Share on FacebookShare on Twitter
  • danger boy
    danger boy Posts: 15,722
    edited February 2003
    Options
    why daisy chain instead of how Dr recommended. To me.. the y cable from the LFE would make the most sense to me. but other ways may work too.
    PolkFest 2012, who's going>?
    Vancouver, Canada Sept 30th, 2012 - Madonna concert :cheesygrin:
    · Share on FacebookShare on Twitter
  • goingganzo
    goingganzo Posts: 2,793
    edited February 2003
    Options
    same thing but if the in out is cheap you might lose a little sigonal. it is cheaper you dont need a y spliter. eather way will work. it is your choice. when i was testing my new amp with my old subs and some other speakers i used the in/out method and worked fine.
    · Share on FacebookShare on Twitter
  • Dr. Spec
    Dr. Spec Posts: 3,780
    edited February 2003
    Options
    Originally posted by goingganzo
    you might lose a little sigonal.

    That was the only reason I recommended a y splitter instead of jumpering the subs - the amp can cause a signal degradation in some cases (not always).
    "What we do in life echoes in eternity"

    Ed Mullen (emullen@svsound.com)
    Director - Technology and Customer Service
    SVS
    · Share on FacebookShare on Twitter