EQ to help brightness of the 2.3's?

Options
hifidigital
hifidigital Posts: 26
edited December 2006 in Vintage Speakers
I've been mainly using my 2.3's in a HT setup and have been listening to more 2 channel music recently. For HT, I'm satisifed with what I'm hearing, but for stereo music the speakers seem too bright. I don't have the cash to spend on replacing the (6) tweeters, so I was wondering if hooking up an EQ (which I already have) might help tone down the brightness?
Post edited by hifidigital on
· Share on FacebookShare on Twitter

Comments

  • hoosier21
    hoosier21 Posts: 4,408
    edited December 2006
    Options
    that is one thing an EQ can do
    Dodd - Battery Preamp
    Monarchy Audio SE100 Delux - mono power amps
    Sony DVP-NS999ES - SACD player
    ADS 1230 - Polk SDA 2B
    DIY Stereo Subwoofer towers w/(4) 12 drivers each
    Crown K1 - Subwoofer amp
    Outlaw ICBM - crossover
    Beringher BFD - sub eq

    Where is the remote? Where is the $%#$% remote!

    "I've always been mad, I know I've been mad, like the most of us have...very hard to explain why you're mad, even if you're not mad..."
    · Share on FacebookShare on Twitter
  • hifidigital
    hifidigital Posts: 26
    edited December 2006
    Options
    So, how should I hook it up to my Denon AVR-1905? Its a 2 channel EQ and I'm really only concerned with front l/r.

    http://www.denon.ca/hapdfs/avr1905mane.pdf
    · Share on FacebookShare on Twitter
  • Loud & Clear
    Loud & Clear Posts: 1,538
    edited December 2006
    Options
    What would be accomplished by buying just two replacement tweeters, and placing one into each speaker's uppermost tweeter bay? Then buying the other four, perhaps two at a time, at your leisure. Good idea? Bad idea?

    Two Channel Setup:

    Speakers: Wharfedale Opus 2-3
    Integrated Amp: Krell S-300i
    DAC: Arcam irDac
    Source: iMac
    Remote Control: iPad Mini

    3.2 Home Theater Setup:

    Fronts: Klipsch RP-160M
    Center: Klipsch RP-160M
    Subwoofer: SVS PB12NSD (X 2)
    AVR: Yamaha Aventage RX-A2030
    Blu Ray: Sony BDP-S790
    TV Source: DirecTV Genie
    · Share on FacebookShare on Twitter
  • danger boy
    danger boy Posts: 15,722
    edited December 2006
    Options
    i'm with the others.. replacing the tweeters will help. i'd do two at a time.. even it takes you a while to replace them all. it will help tame that nasty brightness better than an eq.

    what interconnects are you using? that will make a difference too..
    PolkFest 2012, who's going>?
    Vancouver, Canada Sept 30th, 2012 - Madonna concert :cheesygrin:
    · Share on FacebookShare on Twitter
  • hifidigital
    hifidigital Posts: 26
    edited December 2006
    Options
    I'm not totally opposed to doing that, but I have an EQ that I figured I'd try first, and heck, its a free solution (if I can figure out how to get it hooked up).

    If that doesn't work out, I may take your advice and do them 1 pair at a time.
    · Share on FacebookShare on Twitter
  • schwarcw
    schwarcw Posts: 7,328
    edited December 2006
    Options
    It's been a long time since I hooked up an EQ, but I think the EQ is installed between your source (CDP or DVD) and the receiver. You may find the harshness comes from around the 13KHz range, tweek that down about a couple of dBs to suit your taste.
    Carl

    · Share on FacebookShare on Twitter