splicing speaker wire
Leo Beck
Posts: 1
Is there any special method to be used when splicing (soldering) 2, 12 gauge copper speaker wires? thanks.
Post edited by Leo Beck on
Comments
-
Not really, I would slip a piece of shrink wrap over it though.
RT1 -
Use both flux and solder then apply heat to the wire not the solder....and dont let it drip on you.
Welcome to the forum
Denon #2900, Denon stereo receiver, Conrad Johnson Sonographe 120 amp, Blue Jeans cables, and Klipsch RF-7's -
On the very first thing I soldered with my new soldering iron I managed to do that within five minutes of playing with it. Damn that hurt :mad: Also try not to put your hand in the drips after they fall and hit the ground / table... again... damn that hurtPolknPepsi wrote:....and dont let it drip on you.
-
Hot very Hot.... Denon #2900, Denon stereo receiver, Conrad Johnson Sonographe 120 amp, Blue Jeans cables, and Klipsch RF-7's
-
Try soldering in a car with shorts on- YOU GET THE IDEA dumb dumb dubm
