Part II - Counterpoint SA-100 tube/mosfet power amp

BlueMDPicker
BlueMDPicker Posts: 7,569
edited June 2005 in Flea Market
-- Withdrawn --
Post edited by BlueMDPicker on
· Share on FacebookShare on Twitter

Comments

  • BlueMDPicker
    BlueMDPicker Posts: 7,569
    edited June 2005
    Back
    · Share on FacebookShare on Twitter
  • BlueMDPicker
    BlueMDPicker Posts: 7,569
    edited June 2005
    Guts
    · Share on FacebookShare on Twitter
  • faster100
    faster100 Posts: 6,124
    edited June 2005
    How would this compare to my parasound 1200II ? Not that i have the money for this, unless i sold my parasound... But curious non the less...
    MY HT RIG:
    Sherwood p-965
    Sherwood sd871 dvd
    Rotel 1075 amp x5
    LSI15 mains
    LsiC center
    LSIfx surround backs
    Lsi7 side surrounds
    SVS pb12/plus2

    2 Channel Rig:

    nad 1020 Pre-amp
    Rotel 1080 stereo amp
    Polk sda 2B
    kenwood grunt Tuner
    realistic lab 450 TT
    Signal cable IC
    · Share on FacebookShare on Twitter
  • BlueMDPicker
    BlueMDPicker Posts: 7,569
    edited June 2005
    Cliff,

    I've never owned Parasound gear and only heard a rig driven with it (Parasound) once. So, I can't offer a comparison.

    If specs help in a comparison, here goes:

    Gain (voltage): 30 dB
    Power Output: 100WPC/8 ohm load, 170WPC/4 ohm load
    Freq. Response: 5 Hz to 100 kHz, min.
    Signal-to-Noise (20-80 kHz, ref 85 W): 92 dB
    Distortion:
    1% THD at 100W, 1 kHz, 8 ohm load
    0.7% THD at 10W, 1 kHz, 8 ohm load
    0.3% THD at 1W, 1 kHz, 8 ohm load
    Output Impedance: 0.9 ohms, typical
    Max. Current Available: 25 amps, r.m.s, measured 1 kHz gated ON for 20 mS, OFF for 480 mS, into 0.1 ohms
    Damping factor: 8.9 referenced to 8 ohms at 1 kHz
    DC Offset: 30 mV, long and short term
    Input Impedence: 100K ohms
    Signal Polarity (Absolute Phase): Non-inverting
    · Share on FacebookShare on Twitter
  • faster100
    faster100 Posts: 6,124
    edited June 2005
    Oh ok, can you say that in english now... :D
    Nah specs i know notta about really... just wondered if ya knew the differences off hand.. between the 2

    Thanks for the info though
    MY HT RIG:
    Sherwood p-965
    Sherwood sd871 dvd
    Rotel 1075 amp x5
    LSI15 mains
    LsiC center
    LSIfx surround backs
    Lsi7 side surrounds
    SVS pb12/plus2

    2 Channel Rig:

    nad 1020 Pre-amp
    Rotel 1080 stereo amp
    Polk sda 2B
    kenwood grunt Tuner
    realistic lab 450 TT
    Signal cable IC
    · Share on FacebookShare on Twitter
  • BlueMDPicker
    BlueMDPicker Posts: 7,569
    edited June 2005
    One *bump*, then it goes in one of the HT rigs as serious overkill.
    · Share on FacebookShare on Twitter