New to me SRS 2s

Over the last 3 days I've added three new sets of polks, a pair of SRS 1.2TLs, SRS 2s, and Monitor 5JR series 2s

This thread is for the SRS 2s and their associated project.

https://imgur.com/a/sqNzhSq

Both pairs of SRSs were from the same seller, the TLs are in perfect shape but SRS 2s.....not so much.

Someone has been in both before (owner claims he did but his neighbor may have in the early 2000s, he doesn't remember) and unfortunately while I did get a set of 4 RD0-194s out of it I also have an unknown driver (with coil rub) in the left channel stereo array lower position, a MW6510 in the same position on the right channel, a replaced MW6511 above that driver, and a dead MW155 on the right channel. The right crossover also has a blown component that I think is the poly switch, left terminal plate has a snapped post and there is one stripped thread hole on the right cabinet as well.

Cabinets other than the striped thread are in otherwise good shape, I have two small cracks between the boards on the top plates but that's it. Grills etc are all perfect

I'm going to be upgrading these fully with all the usual mods and VR3 crossovers, I will also likely replace all drivers with the set out of my original SDA1c set because I know those are all perfect and have never been overdriven.

Not sure what I'm going to do about the MW155 though, that's the most major issue I'm dealing with