Does anyone know which specific hurricane nuts to use for the Polk monitor 10b drivers?

manimal87
manimal87 Posts: 3
in Vintage Speakers
Does anyone know which specific hurricane nuts to use for the Polk monitor 10b drivers?
· Share on FacebookShare on Twitter

Answers

  • VR3
    VR3 Posts: 29,383
    I always use 8-32
    - Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 51,655
    You need to drill out the holes in the cabinet slightly. You need to draw the hurricane nut SLOWLY into the hole using a screw of the proper thread size. Over torquing will end in tears.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • VR3
    VR3 Posts: 29,383
    I like to put a dab of power grab on the base of the hurricane nut during install as well
    - Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
    · Share on FacebookShare on Twitter