4 Speakers from Polk A1

I recently purchased a Polk A1 amp with the intent to drive 2 pairs of in-ceiling Klipsch R-1800 speakers, which are rated at 8 ohms. Should I have any concern about trying to drive these? Also, can I just connect 2 speakers to each speaker pair post, or should I wire in a different way?

Comments

  • tonybtonyb Posts: 30,400
    I believe the A1 powers one set of speakers. To power 2 sets you'd need another amp.
    HT SYSTEM-2 channel
    Sony 850c 4k
    Pioneer elite vhx 21
    Sony 4k BRP
    SVS SB-2000
    Dynaudio Audience 72
    Polk FX500 surrounds
    Cary xciter dac
    Cullen modded Sonos
    Joule la-100 pre
    B&k Ref 4420 amp

    Cables-
    Acoustic zen Satori speaker cables
    Acoustic zen Matrix 2 IC's
    Analysis plus crystal oval ic's
    Wireworld eclipse 7 ic's
    Audio metallurgy ga-o digital cable

    Kitchen

    Sonos zp90
    B&k 1430
    Tad 803 speakers
  • if they are 4 ohms each speaker -- you can hook them up in series

    even 8 ohms but in series it will change 8 ohms into 16 ohms..

    how you do this is use 2 speakers for right channel take a from amp, the positive to 1 of the speakers positive post and the negative to the other speakers negative post.. then hook up the 2 post on the speakers that are not used to each other.. use a ohms tester to see what the load is..

    if they are 8 ohms you can hook them up paralleled if the amp is stable to lower ohms like 2 ohms (not recommended) if the amp only goes low as 4 ohms!!!! if they are 16 ohms then this be ok..
Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!