Monitor 10, Series 2 Update
I recently purchased a pair of Monitor 10, Series 2 and wish to update crossovers. What caps and resisters are recommended? Where can I find an electrical schematic? I currently play HPM-100s on SX-1050 and plan to play M10s on Sansui G-6000. Any advice or recommendations... Thank you.
Comments
-
This thread may have the schematics you are looking for.
This is what I think the exact one you are looking for
"....not everything that can be counted counts, and not everything that counts can be counted." William Bruce Cameron, Informal Sociology: A Casual Introduction to Sociological Thinking (1963) -
On the series 2 update the tweeters to the RDO-198, purchase from Polk.Since we don’t know where we are going we have to stick together in case someone gets there….Ken Kesey
To learn who rules over you, simply find out who you are not allowed to criticize.
– Kevin Alfred Strom
The creatures outside looked from pig to man, and from man to pig, and from pig to man again; but already it was impossible to say which was which.”……George Orwell-Animal Farm. -
Use Sonicaps and Mills resistors.Since we don’t know where we are going we have to stick together in case someone gets there….Ken Kesey
To learn who rules over you, simply find out who you are not allowed to criticize.
– Kevin Alfred Strom
The creatures outside looked from pig to man, and from man to pig, and from pig to man again; but already it was impossible to say which was which.”……George Orwell-Animal Farm. -
Before ordering always double check the XO for parts that Polk used. Sometimes Polk made changes on the fly that are not always indicated on the schematic.
