Quick MIT AVT1 Connection Question

PrazVT
PrazVT Posts: 1,607
edited April 2012 in Basic Hookup/Wiring Questions
Just received a pair of AVT1 ICs for my LSi9 rig (AVT2 speaker interfaces). Unlike my other MIT stuff, these don't have directional arrows. Which side is suggested to be connected to source? The short end from the network box or the long end?

Thanks,

- Praz
Dali Optikon 1Mk2
NAD D3020 V2
Schiit Bifrost 2/64

..the rest are headphone setups.
· Share on FacebookShare on Twitter

Comments

  • heiney9
    heiney9 Posts: 25,404
    edited April 2012
    The instructions should say (assuming these are new and shipped with instructions). I say this because I can't remember.

    In visualizing my set up the network boxes are on the speaker end. (short end to speakers)

    H9
    "Appreciation of audio is a completely subjective human experience. Measurements can provide a measure of insight, but are no substitute for human judgment. Why are we looking to reduce a subjective experience to objective criteria anyway? The subtleties of music and audio reproduction are for those who appreciate it. Differentiation by numbers is for those who do not".--Nelson Pass Pass Labs XA25 | EE Avant Pre | EE Mini Max Supreme DAC | MIT Shotgun S1 | Puritan Audio PSM136 Pwr Condtioner & Classic PC's | Legend L600 | Roon Nucleus 1 w/LPS - Tubes add soul!
    · Share on FacebookShare on Twitter
  • pitdogg2
    pitdogg2 Posts: 26,930
    edited April 2012
    sound travels TO the network box. it should be on the end information is going TO. So say your going from pre to amp box on amp end short ends to amp.
    · Share on FacebookShare on Twitter
  • PrazVT
    PrazVT Posts: 1,607
    edited April 2012
    I think you guys are right - the CVT 2 ICs in the HT rig are the same way. Short end to the amp, long end to the DAC.

    Thanks!

    Praz
    Dali Optikon 1Mk2
    NAD D3020 V2
    Schiit Bifrost 2/64

    ..the rest are headphone setups.
    · Share on FacebookShare on Twitter