got the cardas RCA's on the 535
nadams
Posts: 5,877
I just haven't had time to do it, but I went ahead and got 'er did tonight...
I'm still at a loss as how to best upgrade the speaker terminals to nicer binding posts....
I'm still at a loss as how to best upgrade the speaker terminals to nicer binding posts....
Ludicrous gibs!
Post edited by nadams on
Comments
-
Looks good, Noah. Are the binding posts board mounted?Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Yeah, they're soldered directly to the board that has the 4 big caps on it.Ludicrous gibs!
-
Ok, you'll have to run wire from the points on the board to the new posts. Just determine what gauge wire will fit into the holes, order some along with the posts and you're set.
If that doesn't make sense, I'll try again.:)Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
makes sense... sounds like a lot of work
at this point, the stock connections are working fine. I only replaced the RCA's because the originals had a sleeve missing.Ludicrous gibs! -
I can't tell from the above pics, but you should be able to remove the ps board, which should make for an easy upgrade job.
BTW, you can just remove the second set (B) of posts and get some plastic plugs to fill in the holes.Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk
