-
Re: I completely changed my mind about the Polk RTA 15TL. They're not very good.
Denon AVR-3808ci Front: 130 W + 130 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.) 160 W + 160 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.) Denon specifies 6 to 16 ohm speaker for 2ch 8 to 16 ohms for surr…2 · -
Re: I completely changed my mind about the Polk RTA 15TL. They're not very good.
I played with a few Denon receivers and my RTA-11TL's. A 2ch DRA-825R was ok but it was night and day when I upgraded to a DRA-835R. They have basically the same wattage rating but the DRA-835R drive…1 · -
Re: Parasound 1200mk2 issues
I was going to suggest cracked solder joints. I have an HCA-1000A that suffered from this on the bias resistors. Might give the bottom of the board a very good look over and reflow any that look susp…1 · -
Re: "The Minimus" Project
The pads seem to make the most difference with grills on. I guess this makes sense since there would be reflections off the grill that are apparently absorbed by the anti-diffraction pads. Bottom lin…2 · -
Re: Monitor 4 Series bookshelf speaker identification crossover upgrade
I believe sometimes Polk used old labels on early release model changes to use them up.1 ·