custom box

Systems
Systems Posts: 14,873
edited October 2008 in Custom Fabrication
I'm trying to fabricate the box design that is available at polk.com but with a few changes to fit my car perfectly. It's a 2.1 cubic ft single bandpass for the MM120. The modifications I have made to it place it's height at about 12.5" internal height. With the .75" of mdf on top there would be about a quarter inch of space between the bottom and the 13" vents... is this too little? I've been doing a bit of research on the matter and have found that sometimes people put the ports on the outside. Would this be a possibility? I'm planning on the front and back of the box being plexiglass and I'm wondering what size plexiglass would be safe to go with. I'm using 3/4" mdf on everything else. And finally I'm curious if the MM124 would work in this box the same as the MM120
Testing
Testing
Testing
Post edited by Unknown User on

Comments