2 Channel Amps

2»

Comments

  • wlrandall
    wlrandall Posts: 440
    edited December 2002
    Kanicker,

    Yes, the PA is being used in bridged mode. Pre outs on my AVR are split with "Y" cables, one side is fed back to main in, the other goes to the PA. Balance is not a problem, the AVR puts out 110W/ch stereo, 100W/ch surround. Speakers are biamped but not biwired from each amp (only two cables going to each speaker). The AVR amps are driving the low end and the PA the highs. Hope this makes sense.

    Wally