Yamaha Polk & impedance switch
Options
bignorm
Posts: 120
Hello
I am trying to get a simple answer to the following question:
I have the Yamaha RX-V1300 receiver with an impedance switch setting of 4 ohms main and 6 ohms rears & center OR all speakers at 8 ohms. (I currently have it set to 8 ohms)
I have the Polk RTi70 mains CSi30 center and FXi30 surrounds
all have (per the owners manual) a "nominal 4 ohm impedance"
Here is my simple question: What should the impedance switch on the Yamaha be set at????
Thanks
I am trying to get a simple answer to the following question:
I have the Yamaha RX-V1300 receiver with an impedance switch setting of 4 ohms main and 6 ohms rears & center OR all speakers at 8 ohms. (I currently have it set to 8 ohms)
I have the Polk RTi70 mains CSi30 center and FXi30 surrounds
all have (per the owners manual) a "nominal 4 ohm impedance"
Here is my simple question: What should the impedance switch on the Yamaha be set at????
Thanks
Eliab/Dave Abrams calibrated Panny
Yamaha,Denon,Toshiba "in the rack"
Polks all around
SVS on the floor
Yamaha,Denon,Toshiba "in the rack"
Polks all around
SVS on the floor
Post edited by bignorm on
Comments
-
but I accept no responsibility for damaged gear!
www.audioholics.com/FAQs/020919_receiver_settings.phpTesting
Testing
Testing -
just checked out the online specs and manual
both indicate 8 ohms for these speakers...I must have incorrect
n=manualsEliab/Dave Abrams calibrated Panny
Yamaha,Denon,Toshiba "in the rack"
Polks all around
SVS on the floor
