SDA-2B interconnect cable

Options
Looking for a SDA-2B interconnect cable.

Comments

  • agfrost
    agfrost Posts: 2,421
    Options
    Your 2B a pin-blade, or a blade-blade connector?
    Jay
    SDA 2BTL * Musical Fidelity A5cr amp * Oppo BDP-93 * Modded Adcom GDA-600 DAC * Rythmik F8 (x2)
    Micro Seiki DQ-50 * Hagerman Cornet 2 Phono * A hodgepodge of cabling * Belkin PF60
    Preamp rotation: Krell KSL (SCompRacer recapped) * Manley Shrimp * PS Audio 5.0
  • kkritsilas
    Options
    I am looking for the same cable for my SDA-2Bs. In my case, it is pin & blade.
  • F1nut
    F1nut Posts: 49,789
    Options
    Search Neutrik SpeakOn here.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."


    President of Club Polk

  • Airplay355
    Airplay355 Posts: 4,298
    Options
    I used a run of speaker wire into the pin part. I think the blade part doesn't actually carry any signal so it might get you by until you're able to get a cable.
  • audioluvr
    audioluvr Posts: 5,432
    Options
    Wedding pic as his avatar... He's probably busy
    Gustard X26 Pro DAC
    Belles 21A Pre modded with Mundorf Supreme caps
    B&K M200 Sonata monoblocks refreshed and upgraded
    Polk SDA 1C's modded / 1000Va Dreadnaught
    Wireworld Silver Eclipse IC's and speaker cables
    Harman Kardon T65C w/Grado Gold. (Don't laugh. It sounds great!)


    There is about a 5% genetic difference between apes and men …but that difference is the difference between throwing your own poo when you are annoyed …and Einstein, Shakespeare and Miss January. by Dr. Sardonicus