LSI9 Troubleshoot, Tweeter

Options
Patchouli
Patchouli Posts: 9
edited December 2017 in Speakers
Tweeter Dead in Left Speaker.

Swap Tweeters.

Tweeter Dead in Left Speaker.

Play with RCA cables, L/R on amp.

Look at crossover. One badly burnt resister, one mildly burnt.

Order 2 new crossovers. Take speakers apart. Replace crossovers.

Tweeter Dead in Left Speaker.

Swap Tweeters.

Tweeter Dead in Left Speaker.

Swap L/R RCA cables into back of amplifier.

Tweeter Dead in Left Speaker.

Swap speaker wires, connect L speaker output on amp to R speaker, connect R output on amp to L speaker.

Tweeter Dead in Left Speaker.

While playing music all woofers are woofing.

Now what?

Comments

  • Patchouli
    Options
    Note that I play music at lower volume at put my ear right next to each tweeter. It's not lower output it's dead.

  • F1nut
    F1nut Posts: 49,802
    edited December 2017
    Options
    Bad internal wire or connection.

    Why order new crossovers when you could have simply replaced the resistors for considerably less money!!!
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."


    President of Club Polk

  • Patchouli
    Patchouli Posts: 9
    edited December 2017
    Options
    Because one was burnt so bad the board was literally fried and delaminated.

    Note on these speakers the wires are soldered onto the crossovers so changing the crossover also replaced every wire in the speaker.
  • F1nut
    F1nut Posts: 49,802
    Options
    Ha, good reason.

    Are the jumpers in place and are they screwed down tight?

    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."


    President of Club Polk

  • tonyb
    tonyb Posts: 32,906
    Options
    Problem has to be with a faulty crossover. I know it's a pain, but swap crossovers, only way to know for sure.
    HT SYSTEM-
    Sony 850c 4k
    Pioneer elite vhx 21
    Sony 4k BRP
    SVS SB-2000
    Polk Sig. 20's
    Polk FX500 surrounds

    Cables-
    Acoustic zen Satori speaker cables
    Acoustic zen Matrix 2 IC's
    Wireworld eclipse 7 ic's
    Audio metallurgy ga-o digital cable

    Kitchen

    Sonos zp90
    Grant Fidelity tube dac
    B&k 1420
    lsi 9's
  • Tony M
    Tony M Posts: 11,017
    Options
    I HATE electrical problems !!! :s
    Most people just listen to music and watch movies. I EXPERIENCE them.