Tandberg TL 5010 Speakers

2»

Comments

  • Update:
    Ordered Mills resistors from Sonic Craft and Dayton capacitors from P.E.
    Also ordered some of the P.E. speaker gasket material. I'm going to stick with the stock inductors to keep cost down for this project.
  • corticocortico Posts: 397
    No affiliation, sonic craft people are nice to deal with. Post some pics!
    "If it measures good and sounds bad, -- it is bad. If it sounds good and measures bad, -- you've measured the wrong thing." Daniel Von Recklinghausen
  • ConradiclesConradicles Posts: 5,627
    Challenges! Should not be too hard.xgrmtekkncbn.jpg
    bmxp69b6823l.jpg
  • lightman1lightman1 Posts: 9,392
    Challenges! Should not be too hard.xgrmtekkncbn.jpg
    bmxp69b6823l.jpg

    Ten pounds of bullpewp in a five pound bag, Eric.
  • mhardy6647mhardy6647 Posts: 17,335
    may need to extend the leads a wee bit on them Daytons ;)

    (or just rebuild the whole XO on a piece of perfboard or suchlike)

    Not seein' a big problem here (FWIW)

    :)
    "It's like watching a roomful of people who couldn't get through college algebra discussing the flaws of quantum physics theory. I guess it could be fun, but it's ultimately a waste of time." -- seen on audiokarma

    "Some amps run on self bias, some amps run on fixed bias. But his amps run on confirmation bias." -- seen on audioasylum

    "Writing about hifi is like dancing about architecture" -- paraphrasing some wag (possibly Frank Zappa)
  • xschopxschop Posts: 793
    Can you alternate (over/under) the caps on the board and make taller standoffs for the board?
  • ConradiclesConradicles Posts: 5,627
    Put one of the resistors on the backside to make it work:

    tgxede2nvirl.jpg
  • Looks like a old farmer trying to stack his new round bales, cause how else do you get a haystack?
    HT Optoma HD25 LV on 80" DIY Screen, Anthem MRX 300 Receiver, Pioneer Elite BDP 51FD Polk CS350LS, Polk SDA1C, Polk FX300, Polk RT55, Dual EBS Adire Shiva 320watt tuned to 17hz, ICs-DIY Twisted Prs, Speaker-Raymond Cable

    2 Channel Thorens TD 318 Grado ZF1, SACD/CD Marantz 8260, Soundstream/Krell DAC1, Audio Mirror PP1, Odyssey Stratos, ADS L-1290, ICs-DIY Twisted , Speaker-Raymond Cable
  • ConradiclesConradicles Posts: 5,627
    Had some time on a rainy day today to get the other crossover completed. Sealed the drivers, added new mounting hardware, finished the cabinets and playing them now. Crossovers are burning in for a few days. Will report back in the future after I get some time with these classic vintage speakers.
2»
Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!